Motioneye Movie Passthrough. The format from my rtsp cams is already h.264 or h.265 so there is no reason to spend the cpu load to transcode. if i enable movie passthrough all works perfectly but i lose my timestamps and frame change motion boxing. You can again set a recording mode to activate only when motion is detected or continuously like a real nvr. These settings are very similar to the still images with some nice additions related to movies like movie format, maximum length and movie passthrough. i just use movie passthrough. In the motioneye logs, i get… motion docs say of the motion_passthrough parameter: movies settings in motioneye. with video passthrough, the resulting file is encoded based on the parameters set by the camera (in your case with 3 fps and an image size of. i normally use movie passthrough as it can greatly reduce cpu load. When using a rtsp, rtmp, mjpeg and some v4l2 cameras,.
In the motioneye logs, i get… These settings are very similar to the still images with some nice additions related to movies like movie format, maximum length and movie passthrough. i normally use movie passthrough as it can greatly reduce cpu load. movies settings in motioneye. if i enable movie passthrough all works perfectly but i lose my timestamps and frame change motion boxing. When using a rtsp, rtmp, mjpeg and some v4l2 cameras,. i just use movie passthrough. The format from my rtsp cams is already h.264 or h.265 so there is no reason to spend the cpu load to transcode. You can again set a recording mode to activate only when motion is detected or continuously like a real nvr. with video passthrough, the resulting file is encoded based on the parameters set by the camera (in your case with 3 fps and an image size of.
How to configure motionEye to only capture video if there are movements
Motioneye Movie Passthrough with video passthrough, the resulting file is encoded based on the parameters set by the camera (in your case with 3 fps and an image size of. When using a rtsp, rtmp, mjpeg and some v4l2 cameras,. i normally use movie passthrough as it can greatly reduce cpu load. i just use movie passthrough. In the motioneye logs, i get… movies settings in motioneye. with video passthrough, the resulting file is encoded based on the parameters set by the camera (in your case with 3 fps and an image size of. if i enable movie passthrough all works perfectly but i lose my timestamps and frame change motion boxing. These settings are very similar to the still images with some nice additions related to movies like movie format, maximum length and movie passthrough. You can again set a recording mode to activate only when motion is detected or continuously like a real nvr. motion docs say of the motion_passthrough parameter: The format from my rtsp cams is already h.264 or h.265 so there is no reason to spend the cpu load to transcode.